PDA

View Full Version : thumbthing by steave fearson


DaShark
04-21-2007, 01:36 AM
anyone want it?

Ring Master
04-21-2007, 01:36 AM
I DO! Please.

777kong
04-21-2007, 11:29 AM
I want,please apply me
richard138138@yahoo.com.hk

Aereostophanes27
04-21-2007, 12:15 PM
I want it. Post me at icky4259@sbcglobal.net

DaShark
04-21-2007, 03:52 PM
ill post it here. ok?

DaShark
04-21-2007, 03:59 PM
never mind put up email if you want it

Ring Master
04-21-2007, 04:04 PM
gpardee1216@yahoo.com , Please.

DaShark
04-21-2007, 04:14 PM
how do i copy and paste? it wont let me. HELP!!!

DaShark
04-21-2007, 04:15 PM
gonna post here but i cant copy and paste it. how do i do that?

Djforlife1
04-21-2007, 08:16 PM
gonna post here but i cant copy and paste it. how do i do that?

give us the url then!

DaShark
04-21-2007, 08:41 PM
wont give url.

brandyn
04-21-2007, 10:30 PM
post it to youtube

DaShark
04-21-2007, 10:51 PM
start out by placing the two cards that you will staple together to make the holder part of this gimmick face to face. the cards that will be used to make this gimmick will be reffered to as the red cards. take two indifferent cards from your deck and plae them in between the red cards. now center template A against the red card on top of the packet and template B against the back of the red ard on the bottom of the packet. enter the 2 indifferent cards crosswise in the middle of the 2 red cards. you are going to put staples through the holes in the template. the two indifferent cards in the middle will simply act as a spacer. once you have stapled the red cards together, you will remove the two indifferent cards and that will leave enough spae for a single playing card to pass through smoothly. you need to put three staples along each edge of the inner cards running right next to the edges of the inner ards but not penetrating them. start with the enter staple on one side. then make sure the indifferent cards are squared up and flush against the staple you just did. and put another staple in the center of the other side. now it should be a simple matter to put the other four staples in. the double cards can be removed. slip them out of the sleeve and put them aside for the moment. now you must remove the cirular area outlined on the template. you need to cut through both of the stapled together cards. take your time and make a nice clean hole. flip the sleeve over and insert one of the indifferent cards into it. cut along the lines on the template. nothing is removed in this case. you just make a flap on one side of the hole. when you have finished these tasks, carefully remove the paer template from each side of the sleeve. the sleeve is complete. set it aside for now. now you are going to make the ard that pnetrates the thumb or the blade. it requires two new blue cards. align template C to the back of a fresh blue card. cut across the line, removing a strip at the bottom edge of the card. now align the small piece of template C to the small piece of card you have just cut off and cut along the two small lines. finally make a bend in each of the tiny flaps you have made. set this piece aside for the moment. the main portion of the blade is made as follows. align template D to the back of a fresh blue card. cut along the two long black lines creating two long flaps. now cut along the two shorter lines as shown, removing the shaded rectangular corner areas. finally snip a tiny bit off each of the outside corners. be careful not to remove too much here. you need to insert the small piece of the card into the sleeve in the opposite side fro the small trap door by the hole. start with one corner and carefully work the piece into the sleeve finally pushing it inside flush with the edge of the sleeve. now insert the blade card into the other side of the sleeve. slide it through the sleeve guiding the middle flap so it ends up underneath the small end piece. with the cards in this position, you are ready to preform. pull the blade ard back. with the right hand grip the setup. this will hold everything in place as you insert your left thumb into the hole. once youve inserted your thumb into the hole, the right fingers release their grip and instead hold the blade card at the end. now you push the card slowly through the sleeve passing through the base of the thumb. that was a lot of typing. enjoy and cut off your thumb all the time.

DaShark
04-21-2007, 11:08 PM
http://www.megaupload.com/?d=6QM8TF4W

there it is with pics.

DaShark
04-22-2007, 12:31 AM
do you all like it?

huevomax
05-18-2007, 01:14 AM
can you send me the trick plzz?

DaShark
05-20-2007, 09:36 PM
look at link.

baseballfire
05-20-2007, 11:22 PM
thank you!!!!

DaShark
05-20-2007, 11:29 PM
ur welcome

magizak
05-20-2007, 11:57 PM
zschiesser@hotmail.com PLZZZ send!!!!:D